Quick Reference Guide To Administration Procedures - AT&T MERLIN 3070 Administration Manual

Quick Reference Guide to Administration Procedures

This chart summarizes the administrative procedures described on pages 26 through 82. For more information about
a procedure, refer to the page listed.
Before you perform any of these procedures, enter administration mode by following the steps below.
Set switch A on the Processor Module in the control unit to Administer (down).
Insert the administration mode button labels (see the back of this manual) in the administrator/attendant console.
Slide the T/P switch on the left side of the console to P.
When you finish administering your system, leave administration mode by following the steps below.
Slide the T/P switch to the center position.
Set switch A on the Processor Module to Attendant (up).
Remove the administration mode button labels from the console and insert the regular call-handling labels used
by the attendant.
Procedure
PERFORM BASIC ADMINISTRATION
Specify Touch-Tone or rotary
dialing.
(See page 26.)
Assign lines to voice ter-
minals in square systems.
(See page 27.)
Set up line pools in pooled
systems.
(See page 31.)
Assign lines and line pools to
voice terminals in pooled
systems.
(See 33.)
page
Assign Dial Access to Line
Pools.
(See page 38.)
Touch
Adm Misc #302.
Dial
Touch line buttons.
Steady green on = Touch-Tone
Green off = rotary
Touch Adm Misc.
Adm Tel Touch Auto Intercom button representing voice terminal.
Touch line buttons.
Steady green on = line is assigned
Green off = line is not assigned
Touch Adm Tel.
Adm Pool
Dial pool code (9 for main pool or 890 through 899 for addi-
tional pools) if administering more than one line pool.
Touch line buttons.
Steady red on
Red off
Touch Adm Pool.
Adm Tel Touch Auto intercom button representing voice terminal.
Touch line buttons.
Steady green on = line or pool assigned
Touch Adm Tel.
Adm Tel Touch Auto Intercom button representing voice terminal.
Touch same Auto Intercom button again.
Touch line buttons.
Steady green on = dial access to pool containing line
Touch Adm Tel.
Then
= line is in pool
= line is not in pool
Green off = line or pool not assigned
Green off = no dial access to pool containing line
117