Setting Your Control Unit - AT&T MERLIN 3070 Administration Manual

18

SETTING YOUR CONTROL UNIT

The first step in administering your MERLIN system is to set the control unit to con-
form to certain operating conditions of your system. Follow these steps to set your
control unit:
1. Turn off the control unit by setting the On/Off switch on the Power Module
to Off
2. Set switch A on the Processor Module to Administer (down).
Set switch A to this position whenever you need to customize your system
from the administrator/attendant console. When you finish customizing, set
switch A to Attendant (up).
NOTE: Switch A is the only switch on the control unit that you can reset
with the power on. If you reset any other switch with the power on, the con-
trol unit does not record any of the changes you make.
3. Set switches B through H on the Processor Module.
These switches control the voice terminals for intercom numbers 11 through
17, respectively. You can designate any of these seven voice terminals as
attendant consoles. These seven voice terminals plus the administrator/at-
tendant console (intercom 10) provide a maximum of eight attendant con-
soles, should you need them.
For voice terminals that function as attendant consoles, set the cor-
responding switch to Attendant (down).
For voice terminals that function as regular telephones, set the cor-
responding switch to Normal (up).
4. Set the On/Off switch on the Power Module to On. This records the changes
you just made.
5. If you have the optional Service Module (Model 3070 only), which connects
optional equipment, you can make any of the following adjustments:
If you have background music through a loudspeaker paging system,
raise the volume by turning the Bkgd Vol control clockwise, or lower
the volume by turning the control counterclockwise.
If you have Music-on-Hold, raise the volume by turning the MOH Vol
control clockwise, or lower the volume by turning the control
counterclockwise.
If you have a music source with its own amplifier, set the Level switch
to Hi (down); otherwise, set it to Lo (up).
If you have a loudspeaker paging system connected to your MERLIN
system and want a short tone to precede loudspeaker announcement
set the Page Sgnl switch to On (up); if your paging system already pro-
vides a short tone or if you do not want one, set the switch to Off (down).