Extension Count; Extension Interval - E-Mu Xtreme Lead-1 Manual

Extension Count

Extension Interval

The Extension Count parameter specifies how many times the Extension
Interval is carried out. With an Extension Count of 0, the arpeggio plays
only the notes pressed. With an Extension Count of 1, the arpeggio plays
the notes pressed, then plays the same notes (in the same order), trans-
posed by the Extension Interval amount. The cycle is then repeated.
MASTER ARPEGGIATOR
Extension Count
For example, with the Extension Interval set to 12 (an octave) and an
Extension Count of 2, and with the Arpeggiator Mode set to Fwd Assign, if
you played E2, then C2, then G2, the arpeggiated sequence would consist
of: E2, C2, G2, then E3, C3, G3, and then E4, C4, G4. The Extension Count
values range from 0 through 15. Refer to the following illustration.
2
The Extension Interval specifies the additional intervals played when you
press a key. For example, suppose you played C2 with an Interval of 7 (a
Major 5th), Up mode, and an Extension Count of 2. The arpeggio alternates
between C2 and G2.
The Extension Interval values range from 1 through 16.
MASTER ARPEGGIATOR
Extension Interval
Back
1 3 5 4 6
Extend 1
Played
Xtreme Lead-1 Operation Manual 61
Arpeggiator/Beats Menu
Master Arpeggiator Parameters
4
8 7 9
Extend 2
7