Duplicate Flash - E-Mu Xtreme Lead-1 Manual

Duplicate Flash

_ _ _ _
If there are no Flash
SIMMs in the unit, or if the
SIMMs are in the wrong slots,
an error message will be
displayed.
This utility allows you to duplicate Flash SIMMs using Xtreme Lead. Both
Sound and Preset data is copied when a Flash SIMM is duplicated. A factory
sound SIMM cannot be copied using this utility.
WARNING: dangerous voltages are exposed inside Xtreme Lead! Make
sure power is completely disconnected from Xtreme Lead before removing
the top panel. Replace the top panel before restoring power to the unit.
The two sound SIMM sockets in Xtreme Lead are marked 0 and 1. These are
located behind the controller knobs on the circuit board. The Flash SIMM
you want to copy MUST be placed into SIMM Socket 0. The destination
Flash SIMM must be placed in SIMM socket 1.
DUPLICATE SLOT 0 FLASH
Start
Make sure the two Flash SIMM are located in the required Xtreme Lead
1.
SIMM sockets.
Press the Save/Copy menu button.
2.
Rotate the Data Entry Control to select the "Duplicate Flash SIMM"
3.
screen shown above.
Move the cursor to the bottom line and press Enter. The following
4.
screen appears and the Enter LED will be flashing.
Press ENTER to overwrite
the Flash SIMM in Slot 1
Press Enter again to confirm or any other button to abort. The
5.
following screen appears and the SIMM is copied.
DUPLICATING SLOT 0 -> SLOT 1
(Takes about 5 minutes)
When Xtreme Lead has finished duplicating the SIMM, turn power off,
6.
remove the copied SIMM, then reboot. That's it!
Save/Copy Menu
Xtreme Lead-1 Operation Manual 201
Multisetups