Modifying The Tenant Table - Altigen AltiServ HPBX Administration Manual

When a trunk is assigned a tenant ID, the outgoing calls made to this
trunk can be initiated by the tenant users ONLY.
Important:
When creating Tenant entries for IP extensions, the IP trunk
must have the same Tenant Name assigned as the IP extension.

Modifying the Tenant Table

Note: If the administrator changes the tenant group of an extension, Auto
Attendant or DNIS number, the administrator must also check and
change other extensions or system configurations to make sure the
tenant group is not crossed by forwarding, etc. AltiAdmin will not
automatically check and update.
To edit the tenant name:
Double-click the name in the Tenant window (or select the name and
click Edit), then change the name in the dialog box that appears.
To change the extension-to-tenant ID assignment:
Open the Extension Configuration General window, as discussed in
the steps on the previous section under "To assign extensions to tenant
IDs:," and use the Tenant drop-down list to change the tenant ID
assigned to any extension.
If a tenant ID is already assigned, you must change or remove the
assignment from the old extension before you can assign it to a new
one.
Note:
If an extension is assigned to Tenant ID 0 in the Tenant
drop-down list, the extension is able to access all trunks and
extensions, even though the extension/trunks have been
assigned to tenants.
To change the trunk-to-tenant ID assignment:
Open the Trunk Configuration General window and use the Tenant
Selection drop-down list to change the tenant ID assigned to any trunk.
Note:
If a trunk is assigned to Tenant ID 0 in the Tenant Selection
drop-down list, the trunk is accessible to all extensions, even
though there are tenant assignments.
AltiServ HPBX Supplement 11