Belkin F1PI210ENau User Manual page 20

Advanced Setup Method
See the description of the parameters below.
Parameter Description
SSID: Service Set ID. The SSID must be the same on the VoIP Router
and all of its wireless clients. The SSID is the name of your wireless
Show or hide the broadcasting of the SSID. Show SSID broadcasting
on the wireless network for easy connection with client PCs
Note: The SSID is case sensitive and can consist of up to 32
alphanumeric characters. (Default: WLAN)
Wireless Mode: This device supports both 11g and 11b wireless
networks. Make your selection depending on the type of wireless
network that you have. (Default: Mixed mode 11b+11g)
Channel: The radio channel used by the wireless router and its clients
to communicate with each other. This channel must be the same on
the VoIP Router and all of its wireless clients. (Default: 6)
Note: If you experience poor performance, you may be encountering
interference from another wireless device. Try changing the channel,
as this may eliminate interference and increase performance.
Channels 1, 6, and 11, as the three non-overlapping channels in the
2.4GHz range, are preferred
The available channel settings are limited by local regulations.
(Default Range: 1-13)
36
Advanced Setup Method
Access Control
Using the Access Control functionality, you can specify which PCs
can wirelessly connect to the access point. Each PC has a unique
identifier known as a Medium Access Control (MAC) address. With
MAC filtering enabled, only the computers whose MAC address you
have listed in the filtering table may connect to the VoIP Router.
See the description of the Access Control features below.
Parameter Description
Enable MAC Filtering: Enable or disable the MAC filtering function
Access Rule for registered MAC address: When MAC filtering is
enabled, all registered MAC addresses are controlled by this Access
Rule
MAC Filtering Table: Enter the MAC addresses of the network card
you wish to allow or deny connection. (Up to 32 stations)
37
1
2
3
4
5
6
7