Belkin F1PI241EGau Setting-Up Manual

VoIP Broadband Modem
Setting up for ADSL and VoIP.
For models F1PI241EGau and
F1PI241ENau
Congratulations on the purchase of your new
modem/router.
To make the install process as simple as possible we
have pre-confi gured your modem with your username,
password and settings so you can easily connect. Please
follow the simple steps below to setup your modem.
Identify Components
You will fi nd the following items in your modem box:
VoIP Modem/Router
Power Adapter
Line Filter
For using VoIP
You will also need the following items (not supplied with
Modem):
Telephone and
phone cable
2 Connect the supplied line fi lter into a telephone
socket. Connect the supplied telephone cable to the
Modem Modem Modem Modem and connect the loose end of the cable to and connect the loose end of the cable to and connect the loose end of the cable to and connect the loose end of the cable to
A
the "ADSL" socket in the line fi lter. The ADSL LED will
fl ash approximately 6-10 times and then remain solid.
Ensure that the online LED is illuminated. If this light is
not illuminated and you have followed the above steps,
ensure your ADSL line has been activated.
A
Note:
It is recommended that you place a line fi lter on any
telephones or fax machines you have around the house.
You will be shown how to do this in Part Two of this guide.
Ethernet Cable
(blue)
Telephone Cable
Spare Telephone
Cable
Start Here
A ADSL Line Port C
Power LED
B LAN Ports
Part One - Set up for ADSL with your
VoIP Broadband Modem
1 Connect the power adapter into a power outlet. Plug the
other end into the "PWR" socket other end into the "PWR" socket other end into the "PWR" socket other end into the "PWR" socket
your modem on your modem on your modem on your modem on your modem on and the power LED will illuminate. and the power LED will illuminate. and the power LED will illuminate. and the power LED will illuminate. and the power LED will illuminate.
C
D
Power LED will illuminate
C
3 Connect the blue Ethernet cable to one of the available
"LAN" ports on the Modem. Connect the other end
B
of this cable to the network adapter on your computer.
Either Lan 1, 2, 3 or 4 LED will illuminate if you have a
successful connection between your PC and modem.
B
4 Make sure your computer is turned on and once your
operating system is loaded, open your web browser and
surf the web. If you are unable to surf the web, follow the
troubleshooting steps on the next page.
Note for Wireless Users: By default, the wireless feature
of your modem is enabled. For help on confi guring
security on your wireless network, please see the manual
included on the CDROM (applies to Belkin ADSL Wireless
Modem only.)
Power Switch
F PTSN Fail Over
Standard phone
Power select
D E
line
on the modem. Turn on the modem. Turn on the modem. Turn on the modem. Turn
D
LAN LED will illuminate
Continued