Telephone Base Installation - AT&T CL81109 User Manual

Getting started

Telephone base installation

Install the telephone base as shown below.
The telephone base is ready for tabletop use. If you want to change to
wall-mounting installation, see page 9 for details.
1. Plug the small end
of the power adapter
into the power jack
on the bottom of the
telephone base.
7. Raise the antenna.
6. Plug the large end
of the power adapter
into a power outlet
not controlled by a
wall switch.
IMPORTANT INFORMATION
1. Use only the power adapter(s) supplied with this product. To order a replacement
power adapter, visit our website at
1 (800) 222-3111
2. The power adapters are intended to be correctly oriented in a vertical or floor mount
position. The prongs are not designed to hold the plug in place if it is plugged into a
ceiling, under-the-table or cabinet outlet.
2. Route the power
adapter cord
through the slot.
If you have
DSL high speed
Internet service,
a DSL filter (not
included) is
required.
www.telephones.att.com
1 (866) 288-4268
. In Canada, dial
5
3. Plug one end of the
telephone line cord
into the telephone jack
on the bottom of the
telephone base.
4. Place the cords into
the channels.
5. Plug the other end
of the telephone line
cord into a telephone
jack or a DSL filter.
or call
.