Macintosh; Requirements; Enabling And Using Ethertalk - Xerox 6250DP - Phaser Color Laser Printer Reference Manual

Macintosh

This topic includes:
■ "Requirements" on page 3-32
■ "Enabling and Using EtherTalk" on page 3-32
■ "Enabling and Using TCP/IP" on page 3-33
■ "Quick Install Steps for Mac OS 9.x" on page 3-33
■ "Quick Install Steps for Mac OS X, Version 10.1" on page 3-35
■ "Quick Install Steps for Mac OS X, Version 10.2 (Rendezvous)" on page 3-36
■ "Macintosh Troubleshooting (Mac OS 9.x, Mac OS X, Versions 10.1 and 10.2)" on
page 3-37

Requirements

■ A workstation with the appropriate printer driver installed.
■ A working knowledge of the operating system (System 9.0+ or higher) being used on the
workstation.
■ Proper cabling to connect the printer to the network.

Enabling and Using EtherTalk

If you use EtherTalk, Macintosh computers do not require IP addresses.
1. Open the AppleTalk Control Panel. Verify that the Ethernet port is the selected network
port.
2. Insert the Printer Installer and Utilities CD-ROM into the computer's CD-ROM drive. If
your PC is set to autorun, the installer launches automatically.
3. Double-click the installer on the Printer Installer and Utilities CD-ROM to install the
printer driver.
Mac OS 9.x
1.
Open the Chooser, then click the LaserWriter printer driver.
2.
Select the printer.
3.
Click Create to create the desktop printer.
Mac OS X, Versions 10.1 and 10.2
1. Open Print Center.
2.
Click Add Printer, then select the printer.
3.
Click Add.
Note
For more information, go to
Document # 2562.
Copyright © 2003 Xerox Corporation. All Rights Reserved.
www.xerox.com/officeprinting/infoSMART
3-32
Phaser® 6250 Color Laser Printer
to view