AMT Datasouth Fastmark 4600 PLUS Series User’s guide User Manual page 27

4. Close the peeler module using the peel-off mechanism release lever.
(Figure 14)
14
5. Close the top access door and turn on the printer or press the FEED
button if the printer is already on. (Figure 15)
15
1
1
Notes:
 The FEED button does not make the printer peel. For peeling to occur when the
panel setting is properly enabled.
 Make sure the peeler sensor is out of the ribbon path when installed.
Peel Lever
Dispenser Module
Media
Backing/Liner
27