Table of Contents
Advertisement
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
Paste the cushion with pressing
in the direction of arrow.
(2)
B-B SEC
HDD Thermal Plate
Do not bend it at a sharp
angle to put natural R.
To the level of attaching
closely in this range
(15)
Attach the
HDD Cushion
(Black)
Attach the
HDD thermal Plate
0–1
*Ensure the
direction is right.
(lateral)
9-39
When attaching HDD Cushion Plate and HDD Cushion (Black),
set the bending part of the metal plate up.
1~3
Longer Direction
Attach the HDD Cushion (Yellow)
Attach the HDD Cushion (Yellow)
Put the edge on the same line.
I get a gap for
Difference:
breathing hole
securement.
Right and left position: Match to the center
Top and bottom position:
A
(20)
HDD Side Damper
is installed
A
HDD Side Damper
B
B
(Entire Circumference)
HDD Bottom Case Ass'y
1~3
HDD Cushion
(Black)
Metal Plate
1
Make the black damper get into the
both sides of the green damper.
Match the edge of the base
material transparent sheet
to the bottom side
(0)
Lower Case
0~0.5
A-A SEC
Advertisement
Table of Contents
