Table of Contents
Advertisement
Insert FPC into ANT SW PCB.
Match the FPC and the hole on the board.
FPC ASSY
ANT SW PCB
Insert the plug.
Insert position: Match the stiffening
plate and board edge.
9.2.13. Setting the USB PCB and Antenna PCB
1. Open the Connector Cover.
2. Fix the Antenna PCB using the 2 Screws <N3>
(No1 to No2).
3. Connect the Black Cable.
4. Fix the USB PCB using the Screws <N6>.
5. Connect the Cable to the Connector (CN100).
6. Attach the Tape.
Note:
Tighten the Screws in the numbered order (No1 to No2).
Screws <N3>: DRQT2+G6FKL
Screws <N6>: DRQT26+E4FKL
0~1
Match to the
edge of land.
LCD
Protection
Sheet
Attach.
Lock it after FFC is inserted.
Overlap the board and the FPC, and set on the top Cabinet.
Insert the FPC into the main PCB.
Connect the coaxial Cable from Docking PCB.
Screw-1 Tighten
Insert the FPC
into the socket.
Screw-2 Tighten
Fit to the arrow direction
and fix with Screw.
Torque of tightening Screw :0.45 ± 0.05N·m( 4.5 ± 0.5kgf·cm)
Connector
(CN100)
USB PCB
Antenna PCB
Antenna Cable
(Black)
9-30
Lock after inserting FFC.
Ensure that FPC is not bended.
FRAME GUIDE
ANGLE ASM Attach
Screw-3 Tighten
Screw-2 Tighten
Screw-1 Tighten
Tape
<N6>
Connector Cover
No.1
<N3>
No.2
<N3>
Advertisement
Table of Contents
