Panasonic Toughbook CF-30KTPAXxM Service Manual page 42

9.2.7. Setting the Palm Top Cover Sheet, Palm Top Cover, Touch Pad Adhesion Seat,
Touch Pad SW Knob, LED PCB And SW LED PCB
1. Set the SW LED PCB.
2. Attach the Power LED Packing Sheet to the LED Spacer
Sheet.
3. Attach the LEDX6 Spacer Sheet on the SW LED PCB.
4. Fix the SW LED PCB using the Screw <K2-42>.
5. Attach the PW LED Sheet.
6. Pass the Cable of LED PCB through the hole 1 on the
Top Cabinet, then set the LED PCB.
7. Attach the LES Spacer Sheet on the LED PCB.
8. Set the touch Pad SW Knob In and Touch Pad SW Knob
9. Attach the TP Bottom Tape to the Touch Pad.
10. Pass the Cables of the Touch Pad through the hole 2 on
the Top Cabinet, set the touch Pad.
11. Attach the Touch Pad Adhesion Seat.
12. Fix the Palm Top Cover using the 5 Screws <N29>
(No1 to No5).
13. Attach the Palm Top Cover Sheet.
Note:
Tighten the Screws in the numbered order (No1 to No5).
Screws <K2-42>: DRQT26+D4NLT
Screws <N29>: DRQT26+E3FNL
Preparation of SW LED FPC
Attach the Tape
1 1
SW-LED FPC Ass'y
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
Use a pinset.
9-19
No.2
<N29>
No.5
<N29>
No.4
No.1
<N29>
<N29>
No.3
<N29>
Touch Pad Adhesion Seat
Touch Pad
LED
Touch Pad SW Knob
PCB
Touch Pad
SW Knob In
Hole 1
Hole 2
Attach it not to overlap the SW leg.
White Full Line : Mountain Fold
White Dotted Line : Valley Fold
Palm Top Cover Sheet
Palm Top Cover
PW LED Sheet
<K2-42>
PW LED
PCB
SW LED
PCB
Flex Notch Standard 0 1
Attach the Sheet