Table of Contents
Advertisement
S1:Insulation S2:Bitten S3:Sharp Edge
CAUTION
S4:Part No. Check S5:Other
Torque of tightening screw :0.19 ± 0.02N·m( 2.0 ± 0.2kgf·cm)
View from A
direction
HDD GUIDE
BATT HDD CN
Set
ANGLE Set
Note for attaching the Flex to the metal.
Insert so that the
stiffening plate side
touches.
Correct operation
Mountain Fold (Full line)
Valley Fold (Dotted line)
Valley Fold (Dotted line)
Mountain Fold (Full line)
Valley Fold (Dotted line)
Fold along the level of the outer shape.
After folding
Screw
Tighten
FPC HDD BATT Set
Do not fold.
This Connector does not need tetra coating.
Wrong operation
Match the hook of
Connector lock to the center.
Insert FPC into Relay
circuit board Assy's socket
FPC CUSHION
The attention of folding :Breakage countermeasure.
1. The bending inside is R0. 5~1 FIG1
2. Don't mistake a bending direction.
Don't use a mistaken thing.
1. Set HDD GUIDE and fix with Screw.
2. Fix with Screw.
3. Apply tetra coating to each Connector pin.
Battery Connector : Set the nozzle tip apart from the Connector with
1 to 10 mm and spray from the Connector end
to the end for about 1 minute. Do the same to
the opposite direction.
HDD Connector : Set the nozzle tip apart from the Connector with 1
to 10 mm and spray from the Connector end to the
end one way for about 1 minute.
(Refer to M14 in "Common Assembly Instruction Manual".)
View from B
direction
View from C
direction
Insert plug into socket
A
Cable
The terminal of the antenna
cable must not come in
contact with this terminal.
(Put it on the metal fittings
side. )
Figure seen from direction of arrow of A
9-29
Battery Connector
HDD Connector
Screw-1
Screw-2
Tighten
Tighten
FPC insertion guidline
Ensure the FPC edge is
at the steel plate edge.
(Misalignment: 0.5 or less)
Relay circuit board Assy
Reference
1.5mm
Lock after inserting FPC.
Lock FPC
FPC
FIG1
FPC
(R0.5~1)
Advertisement
Table of Contents
