Panasonic Toughbook CF-30KTPAXxM Service Manual page 57

Cautions for Setting GPS ASSY and BT PCB ASS'Y
<Notes>
1. Do not gouge when inserting and removing the plug.
2. Do not damage the coating when handling the Cable.
Pass the Cable
behind the
Cabinet protrusion
WHIP ANT CABLE SUB ANT CABLE MAIN ANT CABLE
Do not protrude
from this side
Cross-section view of cushion
9.2.16. Setting the KB Cable Cover, Keyboard and LCD Cable Cover
1. Set the Keyboard on to the Computer.
2. Connect the 2 Cables to the 2 Cables (CN13,CN14).
3. Fix the KB Cable Cover using the 7 Screws <N29>
(No1 to No7).
4. Fix the LCD Cable Cover using the 3 Screws <N29>
(No1 to No3).
Note:
Tighten the Screws in the numbered order (No1 to No7).
Tighten the Screws in the numbered order (No1 to No3).
Screws <N29>: DRQT26+E3FNL
S2
CABLE SHEET
Attach
S2
Cabinet Level Standard
Tolerance 0 to 1
Process the wire into the groove
CABLE SHEET
Attach
Insert the
Cable plug
Ensure the Cable
does not come over
the cushion.
S1:Insulation S2:Bitten S3:Sharp Edge
CAUTION
S4:Part No. Check S5:Other
TOP CASE SHEET
Attach
Match to the boss center.
<Note>
Each Cable must fit
in the slit of ANT Cable cushion securely.
The Cable must not cross
at the ANT Cable cushion part.
to Connector
(CN14)
to Connector
(CN13)
Keyboard
9-34
Match to the level edge
of Cabinet
Wire process: Fit to the plate squeeze line
Tape
Attach
Tape
Attach
2
No.2
No.3
<N29>
<N29>
No.7
No.1
No.4
<N29>
<N29>
<N29>
No.5
<N29>
No.6
<N29>
Connector
(CN13)
KB Cable Cover
No.2
<N29>
No.3
<N29>
No.1
<N29>
LCD
Cable Cover
Connector
(CN14)