Table of Contents
Advertisement
9.2.3.
Setting the Inverter PCB, TS PCB and LCD Unit
1. Set the LCD Unit to the LCD Front Cabinet in order.
2. Attach the 2 drop holders.
3. Connect the Cable to the Connector. (CN200,CN201)
4. Connect the 3 Cables to the 3 Connectors.
5. Fix the Inverter PCB using the 2 Screws <N6>
(No1 to No2).
Note:
Tighten the Screws in the numbered order (No1 to No2).
Screws <N6>: DRQT26+E4FKL
Preparation of Inverter
N0GF1J000009
(Non T/S model)
INV PCB
Check the
product number.
N0GF2J000003
Board attachment
Match the board edge and the case edge.
Misalignment: 0.5mm or less
Prepare INV Shield Case
INV Shield
Check the
and INV Shield Case
Case
product number.
Outside for Assysite.
N0GF1J000009
S4
INV Shield Case Set
S4
INV Case
Set and attach.
Attach it putting the protrusion mark next to the caution label.
<Notes>
1. Apply the load when attaching the attaching parts. 20 to 30N (2 to 3Kgf)/cm2
2. When handling INV PCB, do not bend or add an impact.
CAUTION
LCD Drop Holder
LCD Unit
LCD Front Cabinet
INV Shield Case Outside
Wrap 2 INV Shield Tapes around INV Shield
Case and attach.
Ensure that INV Shield Tape does not run over
the edge of INV Shield Case.
<INV Shield Tape's Attachment Guide>
Protrusion by wrinkles, etc. = 0.2 or less
Air Bubble = 1 cm2 or less / 1 bubble size
INV Shield Tape Attach.
S1:Insulation S2:Bitten S3:Sharp Edge
S4:Part No. Check S5:Other
9-12
C
Connector
Connector
(CN201)
(CN200)
TS PCB
LCD Drop
A
Holder
B
Inverter PCB
No.1
<N6>
C
No.2
<N6>
B
A
to Connector
(CN200)
Advertisement
Table of Contents
