Table of Contents
Advertisement
9.2.12. Setting the FPC HDD BAT
1. Fix the FPC HDD BAT using the Screw <N16>.
2. Connect the 2 Cables to the 2 Connectors (CN7,CN8).
3. Connect the Cable to the Connector (CN800).
4. Attach the PAD Protect Sheet.
5. Connect the Cable to the Connector (CN9).
6. Attach the Tape.
7. Connect the 2 Cables to the 2 Connectors (CN10,CN26).
8. Attach the Tape.
9. Attach the Antenna Cable Sheet on the Main PCB.
10. Fix the HDD FPC BAT using the 3 Screws <N29>
(No1 to No4).
Note:
Tighten the Screws in the numbered order (No1 to No4).
Screw <N16>: DRQT26+E5FKL
Screw <N29>: DRQT26+E3FNL
Preparation of HDD FPC ASS'Y
S1:Insulation S2:Bitten S3:Sharp Edge
CAUTION
S4:Part No. Check S5:Other
Fold mountain based
on the white line.
R0.5 to R1
Do not apply the load
on the folding part.
Do not forget folding
Tape
Tape Attach based on the
stiffening plate side and fold
back to the back side.
(Avoid wrinkle or floating.)
Apply the load. 2 to 3 kg
0~0.5
1~3
FPC HDD BAT
No.2
<N29>
No.3
<N29>
HDD Cable Cover
Pad Protect
Sheet
Connector
(CN8)
Connector
(CN7)
Pad PCB
Fix with Screws in order of the rear number of No.
Tape Attach based on the
stiffening plate side
Ex.) Fix in order of Screw-1 to Screw-2.
and fold back to the back side.
Screw-2
(Avoid wrinkle or floating.)
Tighten
Apply the load. 2 to 3 kg
Do not forget folding
BATT CN PIN Cushion
Tape
S3
Torque of tightening Screw :0.19 ± 0.02N·m( 2.0 ± 0.2kgf·cm)
9-28
to Connector (CN8)
to Connector (CN7)
<N16>
No.1
to Connector (CN800)
<N29>
to Connector
(CN26)
Tape
Connector
(CN800)
Screw-1
Tighten
BATT
Guide
Set
Set
Antenna Cable
Sheet
Connector
(CN10)
Connector
(CN26)
Tape
Connector
(CN9)
BATT
CN PIN
Set
Advertisement
Table of Contents
