Table of Contents
Advertisement
Assembly of LCD Unit (Only the model who doesn't have T/S)
<Notes>
1. Apply the load when attaching the attaching parts. 20 to 30N (2 to
3Kgf)/cm2
2. Reusing the attaching parts is impossible.
Fix with Screws in order of the rear number of No.
Ex.) Fix in order of Screw-1 to Screw-2.
Torque of tightening Screw :0.45 ± 0.02N·m( 4.5 ± 0.2kgf·cm)
Connect the LCD Cable.
0~1
Screw Set
NEW GPS
Sheet
Attach.
Fix the Connector..
Top Case
4~6
Sheet-1 Attach.
62~63
5~7
7~9
6~8
41~43
Tape-1 Attach.
Set LCD cable Bush
into the rib firmly.
LCD drop holder Insert
Do not allow the tape to run over the LCD reflection plate.
0~2
Opalescent Screws
outer shape line
0±1
Top Case Sheet-2 Attach.
Confirm the Cable is separated(3 mm or more).
Confirm the sub material tape is wrapped.
2~4
Insert the CN.
Avoid catching of
the INV Cable.
Process the Cable from the
inverter to the bottom side.
Process the LCD Cable on it.
CAUTION
Put the side of the socket pin up
and insert it into the CN of LCD.
Tape-2 Attach.
Insert the CN.
Top Case
Sheet-5 Attach.
Top Case
Sheet-4 Attach.
0~1
LCD cable
BUSH Set
Screw-2
Tighten
Ensure the Cable does not run over the inverter.
S2
Avoid catching the
Cable in the Cabinet
9-15
S1:Insulation S2:Bitten S3:Sharp Edge
S4:Part No. Check S5:Other
3~5
2~4
71~73
59~61
4~6
Top Case
Sheet-3 Attach.
0~1
Avoid catching.
16~18
Screw-1
Tighten
S2
Avoid catching the Cable in the Cabinet
Advertisement
Table of Contents
