Table 5 Led Status - Honeywell NetAXS NX4S1 Installation Manual

The following table indicates the status associated with each LED.

Table 5 LED Status

LED
GREEN
RED
AMBER
OFF
The Ethernet/COM status LED will be green even if no cable is attached.
Note:
NetAXS Access Control Unit NX4S1 Installation Guide, Document 800-00008, Revision A
PWR RUN H485
Power Blink = Multi-
OK normal drop
Receive
Steady =
Data
malfunc-
tion
N/A N/A Trans-m
it Data
N/A N/A TX &
RX
Data
Power Mal- No
Off function Com
H232 DS COM
RS232 Down- 100Mbit
Receive stream
Data Receive
Data
Trans-m Trans-m N/A
it Data it Data
TX & TX & N/A
RX RX
Data Data
No No 10Mbit
Com Com
NetAXS™ NX4S1 Installation
NetAXS™ Startup
LINK RLY RDR
Link Relay Flash at
OK Active read
N/A N/A N/A
TX & N/A N/A
RX
Data
No Relay Normal
Link Off
43