Netaxs™ Nx4S1 Installation; Notices; Warnings And Cautions - Honeywell NetAXS NX4S1 Installation Manual

NetAXS™ NX4S1 Installation

1.0 Notices

1.1 Warnings and Cautions

Fire Safety and Liability Notice: Never connect card readers to any critical
Warning:
entry, exit door, barrier, elevator or gate without providing an alternative exit in
accordance with all fire and life safety codes pertinent to the installation. These fire
and safety codes vary from city to city and you must get approval from local fire
officials whenever using an electronic product to control a door or other barrier. Use of
egress buttons, for example, may be illegal in some cities. In most applications, single
action exit without prior knowledge of what to do is a life safety requirement. Always
make certain that any required approvals are obtained in writing. Verbal approvals are
not valid.
Honeywell Access Systems (HAS) never recommends using WIN-PAK or
Warning:
related products for use as a primary warning or monitoring system. Primary warning
or monitoring systems should always meet local fire and safety code requirements.
The installer must also test the system on a regular basis by instructing the end user in
appropriate daily testing procedures. Failure to test a system regularly could make
installer liable for damages to the end user if a problem occurs.
Earth ground all enclosures for proper installation.
Warning:
Use suppressors on all door locks. Use HAS (part number S-4) suppressors
Warning:
for installation. Honeywell recommends only DC locks.
Personal injury or death could occur, and the equipment could be damaged
Warning:
beyond repair, if this precaution is not observed!
• Before installation, turn off the external circuit breaker which supplies power
to the system, including door locks.
• Before connecting the device to the power supply, verify that the output
voltage is within specifications of the power supply.
• Do not apply power to the system until after the installation has been
completed.
If any damage to the shipment is noticed, a claim must be filed with the
Caution:
commercial carrier responsible.
Electro-static discharge (ESD) can damage CMOS integrated circuits and
Caution:
modules. To prevent damage always follow these procedures:
NetAXS Access Control Unit NX4S1 Installation Guide, Document 800-00008, Revision A
1