Communications Diagnostics; Communications Status; Ethernet Information; Cellular Information - Honeywell L5210 Series Installation And Startup Manual

LYNX Touch Installation and Setup Guide
Programming the Control

Communications Diagnostics

Communications Status – The system provides a status of the IP or Cellular communications paths and
performs a self-test of the AES encryption algorithm as follows:
Message
Cellular:
OR
IP:
Encryption:
AlarmNet Registration:
Ethernet Information – Displays IP information, if the IP communication path is enabled.
Physical Link:
DHCP:
NIC IP Address:
Subnet Mask:
Gateway IP Address:
DNS Server IP Address:
Message
Physical Link
DHCP
Cell Information – Displays GSM information associated with the installed/enabled and registered GSM
3GL/3GLC Communication Module.
Status
GSM Registered
GSM Not Registered Searching For Coverage!
SIM Error!
Cell Registration: SIM Not Active
Cell Registration: Not Registered
RSSI Note: Primary Site Signal strength is displayed by a series of 1 to 5 stars (* weak to ***** strong) or "Not Present" if there is no signal.
To ensure a reliable installation at least 2 (**) stars should consistently be present. Secondary site presence is indicated by
"Present" or "Not Present".
OK Normal; No fault. (IP or Cellular)
Fault Reported! No network connectivity and fault time has expired. (IP or Cellular)
Not Connected No network connectivity over IP and fault time has NOT yet expired.
Not Registered! No network connectivity over Cellular and fault time has NOT yet expired.
Deactivated The Cellular module has been deactivated and is not usable on the network.
No Physical Link No network connectivity over IP and fault time is set to 0.
AES Passed! Test successful.
AES Failed! Test failed.
No Encryption! No encryption algorithm set.
Registered Communication Device is Registered with AlarmNet.
Not Registered Communication Device is not Registered with AlarmNet.
Confirms the physical link connection to the internet and the connections speed.
DHCP (Dynamic Host Configuration Protocol) indicates server is performing satisfactorily.
Displays the IP address assigned to this device
Displays the 32-bit address mask used to indicate the portion (bits) of the IP address that is being
used for the subnet address.
Displays the IP address assigned to the Gateway.
Displays the IP address assigned to the DNS (Domain Name System) server.
10 Mbps or 100 Mbps Link speed of physical connection
Bad No physical connection
OK DHCP address resolved
Bad DHCP address not resolved
Off DHCP disabled
Message
Cell Registration:
Primary RSSI:
GPRS: (2G Only)
(Always available in 3G/4G)
Country:
Network:
Cell: (2G only)
Cell: (3G/4G only)
Base Station: (2G Only)
Pri Sync Code (3G/4G Only)
Channel:
Second Site RSSI:
Home 2G Registered Home with 2G GSM Service
Home 3G Registered Home with 3G/4G GSM Service
Roaming Registered Roaming
Primary Site RSSI level signal strength
(See RSSI
Note below)
(1 to 5 stars or "Not Present" will be displayed)
Yes GPRS Service availability
No GPRS is not available
xxx Country Code
xxx Network Code
LAC xxxxx Local Area Code
xxxx Base Station ID
xxxxxx Base Station ID
xx Base Station Antenna Sector
xxx Primary Sync Code
xxxx Control Channel in use
Secondary Site RSSI level availability
(See RSSI
Note below)
("Present" OR "Not Present" will be displayed)
Searching for cell network.
No SIM card present or SIM card faulty
SIM is not activated
Not registered with cell network
- 32 -
Meaning
Meaning
Meaning