Netaxs™ Nx4L1 Installation; Notices; Warnings And Cautions - Honeywell NETAXS NX4L1 Installation Manual

NetAXS™ NX4L1 Installation

1.0 Notices

1.1 Warnings and Cautions

Fire Safety and Liability Notice: Never connect card readers to any critical
Warning:
entry, exit door, barrier, elevator or gate without providing an alternative exit in
accordance with all fire and life safety codes pertinent to the installation. These
fire and safety codes vary from city to city and you must get approval from
local fire officials whenever using an electronic product to control a door or
other barrier. Use of egress buttons, for example, may be illegal in some cities.
In most applications, single action exit without prior knowledge of what to do
is a life safety requirement. Always make certain that any required approvals
are obtained in writing. Verbal approvals are not valid.
Honeywell never recommends using WIN-PAK or related products for use as
Warning:
a primary warning or monitoring system. Primary warning or monitoring
systems should always meet local fire and safety code requirements. The
installer must also test the system on a regular basis by instructing the end user
in appropriate daily testing procedures. Failure to test a system regularly could
make installer liable for damages to the end user if a problem occurs.
Earth ground all enclosures for proper installation.
Warning:
Use suppressors on all door locks. Use S-4 suppressors for installation.
Warning:
Honeywell Access Systems (HAS) recommends only DC locks.
Personal injury or death could occur, and the equipment could be damaged
Warning:
beyond repair, if this precaution is not observed!
• Before installation, turn off the external circuit breaker which supplies power
to the system, including door locks.
• Before connecting the device to the power supply, verify that the output
voltage is within specifications of the power supply.
• Do not apply power to the system until after the installation has been
completed.
If any damage to the shipment is noticed, a claim must be filed with the
Caution:
commercial carrier responsible.
Electro-static discharge (ESD) can damage CMOS integrated circuits and
Caution:
modules. To prevent damage always follow these procedures:
NetAXS Access Control Unit NX4L1 Installation Guide, Document 7-901099, Revision A 1