Table of Contents
Advertisement
5.1.3
ASUS CrashFree BIOS 3 utility
The ASUS CrashFree BIOS 3 is an auto recovery tool that allows you to restore
the BIOS file when it fails or gets corrupted during the updating process. You
can update a corrupted BIOS file using the USB flash disk or the floppy disk that
contains the updated BIOS file.
•
•
Recovering the BIOS from the USB flash disk
To recover the BIOS from the USB flash disk:
1.
Insert the USB flash disk that contains BIOS file to the USB port.
2.
Turn on the system.
3.
The utility will automatically checks the devices for the BIOS file when found,
the utility reads the BIOS file and starts flashing the corrupted BIOS file.
4.
Restart the system after the utility completes the updating process.
•
•
Recovering the BIOS from a floppy disk
To recover the BIOS from a floppy disk:
1.
Turn on the system.
2.
Insert the floppy disk with the original or updated BIOS file to the floppy disk
drive.
3.
The utility displays the following message and automatically checks the
floppy disk for the original or updated BIOS file.
Bad BIOS checksum. Starting BIOS recovery...
Checking for floppy...
5-6
the USB flash disk,
Prepare
motherboard BIOS before using this utility.
Ensure that you rename the original or updated BIOS file in the floppy disk
or the USB flash disk to P5BPE4L.ROM.
Only the USB flash disk with FAT 32/16 format and single partition can
support ASUS CrashFree BIOS 3. The device size should be smaller than
8GB.
DO NOT shut down or reset the system while updating the BIOS! Doing so
can cause system boot failure!
or the floppy disk containing the updated
Chapter 5: BIOS setup
Advertisement
Table of Contents
