Asus TS300-E5 - 0 MB RAM User Manual page 78

3. Serial ATA connectors (7-pin SATA1-4)
These connectors are for the Serial ATA signal cables for Serial ATA hard disk
drives.
If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID
1, RAID 0+1, and RAID 5 configuration using the Intel
Technology or RAID 0, RAID 1 and RAID 0+1 configuration using the LSI
MegaRAID
These connectors are set IDE mode by default. In IDE mode, you can connect
Serial ATA boot/data hard disk drives to these connectors. If you intend to
create a Serial ATA RAID set using these connectors, set the Configure SATA
as item in the BIOS to [RAID]. See section "4.3.4 IDE Configuration" for details.
P5BP-E/4L
P5BP-E/4L SATA Connectors
•
•
Serial ATA hard disk drive connection
Connector
SATA1/SATA2
SATA3/SATA4
4-10
utility embedded in the Intel
®
®
Use only two Serial ATA RAID connectors for each RAID 0 or RAID 1 set.
When using the connectors in IDE mode, connect the primary (boot) hard
disk drive to the SATA1 or SATA2 connector. Refer to the table below for the
recommended SATA hard disk drive connections.
Setting
Master
Slave
ICH7R Southbridge.
®
SATA1
SATA2
SATA3
SATA4
Use
Boot disk
Data disk
Chapter 4: Motherboard information
Matrix Storage
®