Back Side - Asus TS300-E5 - 0 MB RAM User Manual

Back side

The back side of the SATA/SAS backplane faces the rear panel when installed.
This side includes the power connectors, SATA/SAS interfaces for the motherboard
Serial ATA connectors or the SAS card, an HDD fan connector, and SMBus
connectors.
Power connectors
(connect power plugs from the power supply)
Upper 6-1 pins (J1): SMBus connector (connects the SMB cable from the AUX_PANEL1 connector
on the motherboard)
SATA/SAS backplane jumper settings and HDD ID assignments
The 6-pin jumper J3 allows you to define your desired SATA/SAS configuration.
The picture below shows the location of jumper J3 with pins 1-3 and 2-4 shorted.
ASUS TS300-E5
Fan connector (for HDD fan)
SAS HDD Activity LED
connector (for PX4 model only)
SAS Port 0
SAS Port 1
SAS Port 2
SAS Port 3
Refer to the table for the jumper settings
and the appropriate ID# for each SATA
HDD bay.
J3 setting
(1-3 shorted, 2-4 shorted)
Device
Drive Bay 1
Drive Bay 2
Drive Bay 3
Drive Bay 4
SATA/SAS ID
ID0
ID1
ID2
ID3
2-25