Table of Contents
Advertisement
11. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default , the pin labeled "Chassis Signal" and " Ground" are shorted with
a jumper cap. Remove the jumper caps only when you intend to use the
chassis intrusion detection feature.
P5B-V Chassis Intrusion Connector
12. Front panel audio connector (10-1 pin AAFP)
This connector is for a chassis-mounted front panel audio I/O module that
supports either HD Audio or legacy AC`97 audio standard. Connect one end
of the front panel audio I/O module cable to this connector.
P5B-V Front Panel Audio Connector
•
We recommend that you connect a high-definition front panel audio module
to this connector to avail of the motherboard's high-definition audio capability.
By default, this connector is set to AC'97. If you want to connect a High
•
Definition front panel audio module to this connector, set the Front Panel
Support Type item in the BIOS setup to [HD Audio]. See section 4.4.6
Onboard Device Configuration for details.
ASUS P5B-V
CHASSIS
Azalia-compliant
pin definition
AAFP
(Default)
Legacy AC 97-compliant
pin definition
2-31
Advertisement
Table of Contents
