Table of Contents
Advertisement
4.1.4
ASUS CrashFree BIOS 3 utility
The ASUS CrashFree BIOS 3 is an auto recovery tool that allows you to restore
the BIOS file when it fails or gets corrupted during the updating process. You can
update a corrupted BIOS file using the motherboard support CD, the USB flash
disk, or the floppy disk that contains the updated BIOS file.
•
Prepare the motherboard support CD,
disk containing the updated motherboard BIOS before using this utility.
•
Make sure that you rename the original or updated BIOS file in the floppy
disk or the USB flash disk to P5B-V.ROM.
Recovering the BIOS from the USB flash disk
To recover the BIOS from the USB flash disk:
1.
Insert the USB flash disk that contains BIOS file to the USB port.
2.
Turn on the system.
3.
The utility will automatically checks the devices for the BIOS file when found,
the utility reads the BIOS file and starts flashing the corrupted BIOS file.
4.
Restart the system after the utility completes the updating process.
If your display monitor is connected to the onboard VGA connector, the display
monitor will turn-off and the system will beep once while the CrashFree BIOS 3
starts updating your system. The system will beep once again while the process
is finished, and the display will return after the system restarts.
•
Only the USB flash disk with FAT 32/16 format and single partition can
support ASUS CrashFree BIOS 3. The device size should be smaller than
8GB.
•
DO NOT shut down or reset the system while updating the BIOS! Doing so
can cause system boot failure!
Recovering the BIOS from a floppy disk
To recover the BIOS from a floppy disk:
1.
Turn on the system.
2.
Insert the floppy disk with the original or updated BIOS file to the floppy disk
drive.
3.
The utility displays the following message and automatically checks the
floppy disk for the original or updated BIOS file.
Bad BIOS checksum. Starting BIOS recovery...
Checking for floppy...
ASUS P5B-V
the USB flash disk,
or the floppy
4-5
Advertisement
Table of Contents
