Chassis Intrusion Connector (4-1 Pin Chassis) - Asus B150M-A D3 Manual

13.

Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this connector. The chassis
intrusion sensor or switch sends a high-level signal to this connector when a chassis
component is removed or replaced. The signal is then generated as a chassis intrusion
event.
By default, the pin labeled "Chassis Signal" and "Ground" are shorted with a jumper
cap. Remove the jumper caps only when you intend to use the chassis intrusion
detection feature.
B150M-A D3
B150M-A D3 Chassis intrusion connector
ASUS B150M-A D3
CHASSIS
1-21