Table of Contents
Advertisement
5.5
Creating a RAID/SATA driver disk
A floppy disk with the RAID driver is required when installing Windows
operating system on a hard disk drive that is included in a RAID set.
5.5.1
Creating a RAID/SATA driver disk without
entering the OS
To create a RAID/SATA driver disk without entering the OS:
1.
Boot your computer.
2.
Press <Del> during POST to enter the BIOS setup utility.
3.
Set the optical drive as the primary boot device.
4.
Insert the support CD into the optical drive.
5.
Save changes and exit BIOS.
6.
Press any key when the system prompts "Press any key to boot from the
optical drive."
7.
When the menu appears, press <1> to create a RAID driver disk.
8.
Insert a formatted floppy disk into the floppy drive then press <Enter>.
9.
Follow succeeding screen instructions to complete the process.
5.5.2
Creating a RAID/SATA driver disk in Windows
To create a RAID/SATA driver disk in Windows
1.
Start Windows
2.
Place the motherboard support CD into the optical drive.
When the Drivers menu appears, click JMicron JMB363 Driver Disk to
3.
create a JMicron RAID driver disk.
4.
Insert a floppy disk into the floppy disk drive.
5.
Follow succeeding screen instructions to complete the process.
Write-protect the floppy disk to avoid computer virus infection.
To install the RAID driver:
1.
During the OS installation, the system prompts you to press the F6 key to
install third-party SCSI or RAID driver.
2.
Press <F6> then insert the floppy disk with RAID driver into the floppy disk
drive.
3.
Follow the succeeding screen instructions to complete the installation.
5-40
.
®
:
®
Chapter 5: Software support
2000/XP
®
®
Advertisement
Table of Contents
