When A Message Is Displayed On The Client Computer - Ricoh Aficio MP 171F Troubleshooting Manual

Troubleshooting When Using the Scanner Function
Message
Exceeded max.
page capacity.
Do you want to
send the scanned
data?

When a Message Is Displayed on the Client Computer

This section describes likely causes of and possible solutions for the main error
messages displayed on the client computer when using the TWAIN driver.
Important
❒ If an error message that is not included in this section appears, turn off the
main power switch of the machine, and then turn it on again. For information
about how to turn off the main power switch, see "Turning Off the Main Pow-
er", About This Machine.
5
Message
Clear Mis-
feed(s) in ADF.
Invalid Winsock
version. Please
use version 1.1
or higher.
The name is al-
ready in use.
Check the regis-
tered names.
Cannot add any
more scanning
mode.
Cannot specify
any more scan-
ning area.
Scanner is not
available on the
specified de-
vice.
60
Cause
The number of scanned pages ex-
ceeded maximum page capacity.
Cause
A paper misfeed has occurred in-
side the ARDF.
You are using an invalid version
of Winsock.
You tried to register a name that
is already in use.
The maximum number of regis-
terable scanning modes has been
exceeded.
The maximum number of regis-
terable scanning areas has been
exceeded.
The TWAIN scanner function
cannot be used on this machine.
Solution
Select whether to send the data so
far.
Solution
Remove jammed originals, and
place them again.
Check whether the originals are suit-
able to be scanned by the machine.
Install the operating system of the
computer or copy Winsock from
the operating system CD-ROM.
Use another name.
The maximum number of modes
that can be stored is 99. Delete un-
needed modes.
The maximum number of scan-
ning areas that can be stored is 99.
Delete unneeded scanning area.
Contact your service representative.