back to contents page
Operator Panel
Using the Operator Panel
Understanding the Operator Panel Lights
Restoring the factory settings
Using the Operator Panel
The printer operator panel has two buttons and several indicators that show the status of the printer.
1. Continue button/indicator
Press this button to start single sheet feeder or duplex printing.
l
Press and hold this button to print the Report page.
l
2. Ready/Data indicator
Indicates the printer status, such as receiving and printing data.
3. Tray 1 indicator
Indicates the status of the Tray 1.
4. Single sheet feeder indicator
Indicates the status of the shingle sheet feeder.
5. Toner indicators
Indicates the toner is low or empty.
6. Error indicator
Lights when an error occurred.
7. Jam/Front Cover Open indicator
Indicates that a paper jam occurred or the front cover is open.
8. Cancel button
Press this button to cancel a job.
For details on each indicator, see the table below..
Indicator
Status
Continue
Green on
Green blinks
Ready/Data
Green on
Green blinks
Orange on
Error
Orange on
Orange blinks An error occurred.
Orange blinks The PHD, or belt unit life is over. Clean the CTD sensor.
Tray
Green on
Green blinks
Press the Continue button to start single sheet feeder printing.
Press the Continue button to start duplex printing.
The printer is ready.
Processing or printing or Warming up.
The Power saver mode or Standby mode.
The PHD (Print Head Device), or belt unit, life is coming to an end. Clean the CTD sensor.
Paper is set on the tray.
Reload paper on the tray.
Condition