HP L1000 - 9000 - 0 MB RAM Installation Manual page 50

Server Unpacking and Installation
Stationary L-Bracket Rail Assembly
• Ensure that the rails extend out from the cabinet posts sufficiently to properly and safely support the
equipment being installed.
To install an rp54xx Server on stationary rails in an approved cabinet proceed as follows:
Step 1. Locate the rail mounting height in the cabinet. Allow for the following space requirements:
• For each rp54xx Server, allow 31.8cm (12.5 inches) vertically (7 EIAs or Rack Units (RUs).
• If installing the A5575A rail kit, allow an additional vertical 4.45cm (1.75 inches (1 EIA) each
set of rails.
Step 2. Install sheet metal nut(s) in the vertical cabinet posts at the required height for the kit being
installed:
• Install the first nut either:
— 4.45 cm (1.75 Inches) above the top, or
— 31.8 cm (12.5 inches) below the bottom of the last server.
• If installing a A5562A rail kit, install the second nut in the next frame hole below the first.
Step 3. Hold the rail in place and insert and tighten the screws.
For installation of other qualified cabinet and rail combinations refer to the safety precautions and
instructions accompanying them.
50
31.8 cm
rp54xx
(12.5
Server
inches
4.45 cm
(1.75
Inches
rp54xx
Server
31.8 cm
(14.25
inches
Rail
Rail
A5575A Rail Kit
in approved
Non- E-Series
cabinet shown
Chapter 2