HP L1000 - 9000 - 0 MB RAM Installation Manual page 45

Step 7. Take the left hand slide/bracket assembly (marked 337079-1L) and install it into the left hand
vertical mounting posts. This is done by inserting the pin at the rear of the slide's mounting bracket
into the 23rd hole in the rear vertical mounting post and inserting the hook at the front of the
bracket into the vertical, rectangular slot in the aluminum spacer. The slide should be positioned in
the cabinet so that it is horizontal and level.
Step 8. Securely fasten the rear of the slide's mounting bracket to the rear vertical mounting post by
installing and tightening two of the M5 x 16 screws with cress-cup washers thorough the mounting
post, through the slides mounting bracket and into the threaded nuts attached to the mounting
bracket.
Step 9. Fully extend the slide so that it is locked in the fully open position.
Chapter 2
Guide Pin
Server Unpacking and Installation
Install Stand-Alone Server in a Cabinet
Hook
45