HP L1000 - 9000 - 0 MB RAM Installation Manual page 38

Server Unpacking and Installation
Receive and Unpack A Non-Integrated Server
Step 2. If you are moving the server manually, use three people to lift the server from the packing material
and pallet. Carefully move the server to the selected location.
Step 3. If you are moving the server by an approved lifting device (such as Genie Lift Ô ), remove the tear
flap from the front lip of the carton bottom to allow access to the server, as illustrated below.
Removal of the tear flap will reveal a slot between the bottom of the server and the inside bottom of
the cardboard box.
Step 4. Carefully raise the lift's platform so that it will slide into the slot located under the center of the
server, but over the top of the pallet.
NOTE
38
The server's center of gravity will vary with the hardware configuration, but it is
generally located slightly behind the middle of the server.
Lifting Device
Platform
Chapter 2