HP L1000 - 9000 - 0 MB RAM Installation Manual page 41

NOTE
Alignment Spring Pins
Step 3. Position the server on the wheeled enclosure base.
Step 4. Tighten the two captive screws in the enclosure base to secure the server to the base.
Step 5. Position the enclosure cover (outside skin) over the server and install and tighten the screws to
secure it to the base.
NOTE
WARNING
Step 6. Install the Front Bezel.
Chapter 2
Ensure that the positioning spring pins in the enclosure base align with the
alignment holes in the bottom of the server.
The perforations and the lip of the outside skin should be toward the rear of the
server.
Stacking rp54xx Servers in deskside enclosures is not supported.
Stacking rp54xx Servers in deskside enclosures can damage equipment,
may cause injury to personnel, and may void your warranty or service
contract.
Server Unpacking and Installation
Install Deskside Server
Captive Fastener
41