HP L1000 - 9000 - 0 MB RAM Installation Manual page 14

Installing Additional Components
Installing Memory
Installing rp5470 DIMMs
Step 1. Power down and unplug the rp54xx Server.
NOTE
Step 2. Make the top of the server accessible for service.
Step 3. Loosen the captive T-15 screws that hold the top cover in place, then grasp the strap handle, raise
the cover slightly, and pull the cover toward the front of the server to free the cover tabs from the
slots in the chassis. The air baffle will be exposed.
Step 4. Loosen the four (4) captive T-15 screws on the air baffle. Grasp the two handles on the baffle, and
lift and remove the baffle.
Step 5. Observe electrostatic discharge (ESD) precautions.
Step 6. Refer to the following graphic for memory carrier locations.
14
DC voltages are present when the server is connected to AC power. Do not attempt to
install or service: CPUs, memory, PSMs, the platform monitor or PCI I/O cards
installed in non-turbo slots (1-6) while DC voltage is present. Failure to observe this
warning may result in damage to the server.
Chapter 1