HP L1000 - 9000 - 0 MB RAM User Manual page 96

Utilities
Configuring the Rev B Guardian Service Processor (GSP)
To add a user, perform the following steps:
1. Go into the GSP with the ctrl+b entry.
2. At the GSP prompt, enter the Security options and access control (SO) command:
GSP> so
3. The first prompt you will see with the so command is for GSP wide parameters:
GSP wide parameters are:
Login Timeout: 1 minutes.
. Number of password Faults allowed: 3
. Flow Control Timeout: 5 minutes.
Do you want to modify the GSP wide parameters? (Y / [N]) __
At this point you can modify the GSP wide parameters, or continue with adding users. To add users,
respond N for no.
NOTE If this is the first time users are being added, the first user added will be the GSP
administrator.
If this is not the first time you are adding users (you are adding additional users), you will
need to step through all current users to reach the next available user prompt.
4. The next prompt that appears will ask the following question:
Do you want to modify the user number 1 parameters? (Y/[N]/Q to quit) __
Follow the series of prompts to enter all the required fields for adding a user.
CAUTION Be sure to read each prompt carefully and enter the correct response. A missed or incorrect
entry could deny entry to that user.
An example of an added users information would be:
. User's Name: Joe Smith
. Organization's Name: IT Support
. Dial-back configuration: Disabled
. Access Level: Operator
. Mode: multiple
. User's state: enabled
For the number 1 user, the Access level is administrator. The Mode entry of single
only allows entry for that user one time, then access will be denied. A Mode entry of
multiple allows unlimited entries into the GSP.
82
Chapter 5