HP L1000 - 9000 - 0 MB RAM User Manual page 106

Troubleshooting
Chassis Code to FRU Decode
Table 6-2 Chassis Log Error to FRU Decoder (Continued)
Chassis Log Field Values and Descriptions from
Source Source Detail
3 - PDH Not Applicable
(N/A)
4 - Power 1 - AC Mains
4 - Power 3 - Low Voltage
DC Power
4 - Power 4 - High Voltage
DC Power
6 - Platform 3 - Cabinet Fan
6 - Platform 6 - Service
Processor
6 - Platform 7 - Power
Monitor
7 - Memory 1 - Controller
7 - Memory 4 - SIMM or
DIMM
8 - I/O 6 - Disk
92
Log Entry
Source
ID
N/A
N/A
CPU
Support
Module #
Power
Supply #
Fan #
N/A
N/A
N/A
N/A
N/A
Problem
FRU
Detail
N/A System
Board
9 - Power AC Power
Off
N/A CPU
Support
Module
N/A Power
Supply
N/A Fan
N/A Core I/O
N/A Power
Monitor
N/A System
Board
N/A Memory
DIMM
Various Disk
Values Subsyste
m
Action to Take
Replace the System
Board.
Check that AC is
being supplied to all
power supplies.
Replace the
Processor Support
Module (on the
System Board)
referenced in the
Source ID.
Replace the Power
Supply (in the front
of the system behind
the bezel) referenced
in the Source ID.
Replace the Fan
referenced in the
Source ID.
The Service
Processor is on the
GSP I/O board.
Replace the GSP
Replace Platform
Monitor card.
Replace the System
Board.
Isolate to failing
DIMM using BCH
(IN, ME) and ODE
memory diagnostic.
Use BCH commands
and ODE
diagnostics to check
disk subsystem.
Chapter 6