HP L1000 - 9000 - 0 MB RAM User Manual page 159

WARNING:
VGDISPLAY: WARNING: COULDN'T QUERY PHYSICAL VOLUME "/DEV/DSK/cXtXdX"
THE SPECIFIED PATH DOES NOT CORRESPOND TO PHYSICAL VOLUME ATTACHED TO THE
VOLUME GROUP.
VGDISPLAY: WARNING: COULDN'T QUERY ALL OF THE PHYSICAL VOLUMES.
If you see these messages, the disk was defective at the time the volume group was activated.
Remove the bad disk as described in step 9 of this procedure, then follow the instructions in for
replacing the disk and perform the HotSwap Procedure for Unattached Physical Volumes described
there.
Otherwise, the disk drive became defective after vgchange was run. Proceed to Step 2.
Step 2. Display the names of all the logical volumes on this volume group with the vgdisplay command. For
example:
#vgdisplay /dev/vg00
Step 3. Determine which logical volumes have mirrors with the lvdisplay command. For example:
#lvdisplay /dev/vg00/lvol# | grep -ie "LV Name" -e "Mirror"
Step 4. Determine the pvkey command status for the mirrored logical volume, again using the lvdisplay
command with the -k option. Compare the output to the lvdisplay command with the -v option to
determine the device file to pvkey mapping. For example,
# lvdisplay -v -k /dev/vg00/lvol1
--- Logical volumes ---
LV Name
VG Name
LV Permission
LV Status
Mirror copies
Consistency Recovery
Schedule
LV Size (Mbytes)
Current LE
Allocated PE
Stripes
Stripe Size (Kbytes)
Bad block
Allocation
IO Timeout (Seconds)
--- Distribution of logical volume ---
PV Name
/dev/dsk/c1t6d0
/dev/dsk/c2t6d0
--- Logical extents ---
LE PV1
00000
00001
00002
Chapter 7
/dev/vg00/lvol1
/dev/vg00
read/write
available/syncd
1
MWC
parallel
256
64
128
0
0
off
strict/contiguous
default
LE on PV
64
64
PE1
0 00000 current
0 00001 current
0 00002 current
Individual Component Remove/Replace Instructions
PE on PV
64
64
Status 1 PV2
1
1
1
Removing and Replacing Components
PE2 Status 2
00000 current
00001 current
00002 current
145