Dell Dimension XPS 50 Reference Manual page 62

3-16 Dell Dimension XPS Txxx and Txxxr Systems Reference and Troubleshooting Guide
.
secondary
hard-disk drive
7 . Align the external tabs on the bracket with the slots in the chassis, and slide the
bracket back into place. Secure the bracket to the chassis with the screws you
removed in step 4.
8. Connect a DC power cable and the EIDE cable to the drive as described earlier in
"Connecting Drives."
9. If necessary, connect the EIDE cable to the PRI IDE connector on the system
board.
10. Replace the bezel as described earlier in "Removing and Replacing the Bezel."
11. Make sure that no cable connections were loosened during the procedure.
Arrange cables so that they will not interfere with replacing the computer cover
and support beam.
12. Replace the computer cover and support beam and tighten the cover-mounting
thumbscrew.
13. Reconnect your computer and devices to their electrical outlets, and turn them
on.
14. Verify the correct operation of the drive by running the Dell Diagnostics (refer to
"Running the Dell Diagnostics" in Chapter 4).
screw
drive bracket
tabs (2)