Dell Dimension XPS 50 Reference Manual page 168

C-8 Dell Dimension XPS Txxx and Txxxr Systems Reference and Troubleshooting Guide
#  ( 
 
Extended memory is not
Extended RAM
working correctly or is
Failed at
not configured correctly
offset: nnnn
at offset nnnn.
nnnn is a map of the bits
Failing Bits:
at the RAM address (in
nnnn
system, extended, or
shadow memory) that
failed the memory test.
Each "1" in the map indi-
cates a failed bit.
The hard-disk drive spec-
Fixed Disk n
ified by n is not working
Failure
or is not configured
correctly.
Fixed Disk
Controller
Failure
The system's automatic
Fixed Disk n
drive-type detection fea-
Identified
ture has identified the
hard-disk drive(s).
Diskette drive x is not
Incorrect
correctly identified in the
Drive x type
system setup program.
- Run SETUP
The system is having a
Invalid NVRAM
problem accessing
media type
NVRAM.
NOTE: The Glossary in the system Help defines abbreviations and acronyms.



  
If you receive this message after
making changes in the system
setup program, enter the pro-
gram and restore the original
value(s).
If the problem persists, refer to
Chapter 7 , "Getting Help," for
instructions on obtaining technical
assistance.
If you receive this message after
making changes in the system
setup program, enter the pro-
gram and restore the original
value(s).
If the problem persists, refer to
Chapter 7 , "Getting Help," for
instructions on obtaining technical
assistance.
Ensure that the drive is installed
correctly in the chassis and
defined correctly in the system
setup program.
If the problem persists, refer to
"Hard-Disk Drive" in Chapter 6.
No action is necessary.
Ensure that the drive is defined
correctly in the system setup
program.
Set the configuration jumper to
Maintenance mode (refer to
Table 2-2), and restart the system
to return all settings to their
defaults. If the problem persists,
refer to Chapter 7 , "Getting Help,"
for instructions on obtaining tech-
nical assistance.