Table of Contents
Advertisement
support.dell.com
5.
If a drive is already installed, remove the screw securing the drive to the bracket
and rotate the drive out of the bracket.
6.
Orient the new drive with its circuit board facing the inside of the bracket. Align
the two tabs on the inside of the bracket with two screw holes in the side of the
drive, and rotate the drive into the bracket as shown in Figure 3-13. Secure the
drive to the bracket with one screw on the side opposite the tabs.
secondary hard-disk
drive assembly
card-guide
assembly
drive-assembly
mounting screws (2)
Installing Drives 3-15
Hide quick links:
Advertisement
Table of Contents
