Table of Contents
Advertisement
you are experiencing any of the above symptoms that might indicate voltage
spikes on the power line, you may want to install a surge suppressor between
the power outlet and the system power cord.
Devices are not Recognized under Device Manager (Windows*
Operating System)
The Windows* operating systems do not include all of the drivers for the Intel
NICs, and other components. See
Hard Drive(s) Are Not Recognized
Check the following:
Make sure the drive is not disabled in BIOS Setup.
Make sure the drive is connected correctly and is plugged into the power supply.
Make sure the drive is compatible. See the
tested drives.
Make sure you have not exceeded the power budget for the server. See
and
Software" for a link to software to check your power budget.
If using SCSI drives, verify that each SCSI ID number is uniqe on the SCSI bus & that both
ends of the SCSI chain are terminated. See your drive documentation for details on setting the
SCSI ID for your drives.
If using IDE drives, verify that the master/slave settings are set correctly. See your drive
documentation for details on setting the master/slave settings.
If using a RAID configuration with SCSI or SATA drives, make sure the RAID card is installed
correctly and properly configured.
Bootable CD-ROM Is Not Detected
Check the following:
Make sure the BIOS is configured to allow the CD-ROM to be the first bootable device.
LED Information
®
The Intel
Server Board SE7520BD2 includes LEDs that can aid in troubleshooting your system. A
table of these LEDs with a description of their use can be found in the Intel
SE7520BD2 Technical Product Specification at:
http://support.intel.com/support/motherboards/server/se7520bd2/sb/CS-010682.htm
"Additional Information and
Tested Hardware and Operating System List
Troubleshooting
®
chipsets, on-board
Software".
"Additional Information
®
Server Board
for
53
Advertisement
Table of Contents
