Minimum Hardware Requirements; Installation Notes - Intel SE7501HG2 Product Manual

Minimum Hardware Requirements

To avoid integration difficulties and possible board damage, your system must meet the following
minimum requirements. For more information on supported processors and qualified memory and
chassis components, see:
http://support.intel.com/support/motherboards/server/SE7501HG2
Processor
Minimum of one Intel Xeon processor with 512K cache. For a complete list of supported
processors, see:
http://support.intel.com/support/motherboards/server/SE7501HG2
Memory
Minimum of two 128 MB ECC, DDR266-compliant registered SDRAM 184-pin gold DIMMs.
Power Supply
Minimum of 450 W with 1.2 A +5 V standby current (in order to support Wake On LAN
and 12+ V CPU power support [ATX], which meets the SSI EPS 12 V specification. You must
provide standby current, or the board will not boot.
For more information on the SSI EPS 12 V specification, see:
http://www.ssiforum.org

Installation Notes

Installation Process Quick Reference
Step
Remove the access cover
Install the I/O shield
Install the standoffs
Install the rubber bumper
Install the server board
Connect cables to the server board
Install the processor and processor wind tunnel in the Intel®
Server Chassis SC5200 base chassis or in a reference chassis
Install the processor in the Intel® Server Chassis SC5200 with
Hot Swap Redundant Power
Install memory
1
DDR200 compliant registered ECC DIMMs can be used only if 400 MHz processors are installed.
32
Where the information is located
Your chassis manual
Page 33
Page 35
Page 36
Page 36
Page 38. Refer also to your chassis manual
Page 39
Page 46
Page 51
Intel Server Board SE7501HG2 Product Guide
1
*
(WOL))