Intel SE7501HG2 Product Manual page 83

To use the Server
Configuration utility to
Configure the server for
remote LAN
management
Configure for Remote
Serial / Modem
management
Configure for Serial /
Modem alerting
Configure for LAN
alerting
Run the FRU/SDR Load
Utility
Configure an Asset Tag
Create / modify the
service partition
Create System or Utility
/ Device Diskettes
Save / load
configuration data
Configuration Software and Utilities
Description of procedure
Enable a connection to the server from a workstation on the LAN to
allow remote management functions, such as powering the server on or
off, or running diagnostic utilities.
Enable a connection to the server from a serial or Modem connection to
allow remote management functions, such as powering the server on or
off, or running diagnostic utilities.
Configure the server to send a telephone page in the event that a
hardware or firmware error occurs at the server.
Configure the server to send a notification message to a workstation
segment of the network in the event that a hardware or firmware error
occurs at the server.
Use to update the Field Replaceable Unit (FRU) and Sensor Data
Record (SDR) flash components.
NOTE: You must run the FRU/SDR Load utility whenever the BMC is
updated or if you change your processors.
Assign an identification number or serial number to the server
If a service partition does not already exist, create one. If a service
partition has been created earlier, update it.
Create diskettes by operating system, utility, or device driver
Save the configuration data to a file. Use this saved file to configure
other servers identically.
Page
92
93
96
97
100
104
105
104
106
83