Server Board; Installing The Server Board - Intel L440GX+ Product Manual

top that you can grip with your fingertips or with a pair of fine needle nosed
pliers. If your jumpers do not have such a tab, take care when using needle
nosed pliers to remove or install a jumper; grip the narrow sides of the
jumper with the pliers, never the wide sides. Gripping the wide sides can
damage the contacts inside the jumper, causing intermittent problems with
the function controlled by that jumper. Take care to grip with, but not
squeeze, the pliers or other tool you use to remove a jumper, or you may
bend or break the stake pins on the board.

Server Board

Installing the Server Board

CAUTION
The server board can be extremely sensitive to ESD and always requires
careful handling. After removing it from the server, place it component side
up on a nonconductive, static free surface to prevent shorting out the battery
leads. If you place the board on a conductive surface, the battery leads may
short out. If they do, this will result in a loss of CMOS data and will drain
the battery. Do not slide the server board over any surface.
1. Observe the safety and ESD precautions at the beginning of this chapter.
2. Insert screws through the mounting holes and into the threaded standoffs. Make sure the board
is properly seated, and then tighten all the screws firmly.
3. Connect all internal cables to the server board.
/
NOTE
The floppy cable (Intel Part Number 738992-002) has been modified to
support all floppy drives. The floppy drive connector on the cable (see
connector label) is not keyed. Care should be taken to match pin 1 of the
cable, indicated with a red stripe on the cable, with pin 1 of the floppy drive.
4. Reinstall add-in boards.
5. Connect all internal cables to add-in boards. Make sure you connect the power cables to the
correct power connectors.
6. Connect all peripheral device cables to the I/O panel on the rear of the server.
7. Run the SSU to configure the server.
22 Upgrading