Installing The Server Board; Location Of The Mounting Screw Holes - Intel S815EBM1 - Server Board Motherboard Product Manual

Installing the Server Board

Refer to your chassis manual for instructions on installing the server board. Six screws secure the
server board to the chassis. Figure 6 shows the locations of the mounting screw holes.
✏
NOTES
You will need a Phillips (#2 bit) screwdriver.
Refer to Page 73 for regulatory requirements and installation instructions and precautions.
WARNING
Only qualified technical personnel should attempt this procedure. Disconnect the server from its
power source before performing the procedures described here. Failure to disconnect the power
before you open the server can result in personal injury or equipment damage.
Upgrading
Figure 6. Location of the Mounting Screw Holes
OM12203
23