No Characters Appear On Screen - Intel S5000XVN - Workstation Board Motherboard User Manual

No Characters Appear on Screen

Check the following:
•
Is the keyboard functioning? Test it by turning the "Num Lock" function on and off
to make sure the Num Lock light is functioning.
•
Is the video monitor plugged in and turned on? If you are using a switch box, is it
switched to the correct system?
•
Are the brightness and contrast controls on the video monitor properly adjusted?
•
Is the video monitor signal cable properly installed?
•
Does this video monitor work correctly if plugged into a different system?
•
Is the onboard video controller enabled in the BIOS?
•
Remove all add-in cards and see if the video returns. If successful, add the cards
back in one at a time with a reboot between each addition to determine which card
might be causing the problem.
•
Make sure the memory FBDIMMs comply with the system requirements.
•
Make sure the memory FBDIMMs have been populated according to the system
requirements.
•
Remove the memory FBDIMMs and re-seat them.
•
Make sure the processor(s) comply with the system requirements.
•
Make sure the processor(s) have been populated according to the system
requirements.
•
Remove the processor(s) and re-seat them.
If you are using an add-in video controller board, do the following:
1. Verify that the video works using the onboard video controller.
2. Verify that the video controller board is fully seated in the workstation board
connector.
3. Reboot the system for changes to take effect.
4. If there are still no characters on the screen after you reboot the system and POST
emits a beep code, write down the beep code you hear. This information is useful
for your service representative.
5. If you do not receive a beep code and characters do not appear, the video display
monitor or video controller may have failed. Contact your service representative or
authorized dealer for help.
®
Intel Workstation Board S5000XVN 47