Figure 16. Installing Heatsink (Passive Heatsink Shown) - Intel S5000XVN - Workstation Board Motherboard User Manual

Use the following steps to install a heatsink.
1. Install the processor. See
2. Set the heatsink over the processor, lining up the four captive screws with the four
posts surrounding the processor.
3. Loosely screw in the captive screws on the heat sink corners in the order shown by
Figure
4. In the same order, gradually and equally tighten each captive screw until each is
firmly tightened. Do not fully tighten one screw at a time.
®
Intel Workstation Board S5000XVN
"Installing the Processor" on page 31
16. Do not fully tighten one screw before loosely attaching the others.

Figure 16. Installing Heatsink (passive heatsink shown)

for instructions.
AF000098
35