Removing A Processor - Intel S5000XVN - Workstation Board Motherboard User Manual

Removing a Processor

1. Observe the safety and ESD precautions in
2. Turn off all peripheral devices connected to the workstation. Turn off the
workstation.
3. Remove the AC power cord from the workstation.
4. Remove the chassis cover. See the documentation that came with your chassis for
instructions on removing the cover.
5. Disconnect and remove any components necessary to access the processor sockets.
See the documentation that came with your chassis for instructions on removing
chassis components.
6. Active heatsink only: Unplug the processor fan cable from the workstation board.
7. Loosen the four captive screws on the corners of the heat sink.
8. Twist the heat sink slightly to break the seal between the heat sink and the
processor.
9. Lift the heat sink from the processor. If it does not pull up easily, twist the heat sink
again. Do not force the heat sink from the processor. Doing so could damage the
processor.
Caution:
— Do not attempt to operate your workstation system without a heatsink installed
—
®
Intel Workstation Board S5000XVN
over each installed processor. Doing so will cause your workstation to overheat
and may cause permanent damage.
The heatsink has Thermal Interface Material (TIM) located on the bottom of it.
Use caution when handling the heatsink so you do not damage the TIM.
"Safety Information" on page iii.
37